Saturday, 06 October 2007

Some problem on Quick Aproach

When I was doing experiment on Thursday, I located my samples, and set up the correct safty limit. But after some normal indent and scratch, an error came: the tip detected some excessive force. Then I did quick aproach again. Unexpectedly, the error happened again during the quick aproach.

 

Solve: I deleted all the samples from the  safty limit, and reset them.Do quick approach for all of them.Theproblem solved.

Posted by TriboScan at 22:41:10 | Permanent Link | Comments (36) |
Comments
1 2 3 4
1 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/26 - 09:42:54
2 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/26 - 10:26:14
3 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/26 - 14:33:48
4 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/26 - 19:53:19
5 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/26 - 21:08:11
6 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/27 - 15:44:27
7 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/27 - 17:59:04
8 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/28 - 07:16:16
9 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/28 - 14:06:23
10 - Awesome! (Comment this)

Written by: tor7861 at 2008/06/28 - 22:02:33
Write a comment






1 2 3 4